SilverCrest SIRD 14 C2
212 - English
[Save]
Select this option and press the NAVIGATE knob [3] to save the settings. After an alarm
has been enabled, the display [1] shows a bell icon 1 (Alarm 1) or 2 (Alarm 2). In standby mode,
the alarm time set is also shown on the display [1].
Switching the alarm off
When the alarm starts, you can disable it as follows.
Press any button on the Internet Radio several times or rotate the Navigate knob [3] or the
Volume knob [9] to delay the alarm for 5, 10, 15 or 30 minutes. After this period, the alarm
starts again. The remaining snooze time before alarm reactivation appears at the bottom of the
display [1]. Alternatively, you can use the buttons [21], [22], [26], [29], [32], [33] or [35] on
the remote control to adjust.
Press and hold the VOLUME knob [9] or the On/Standby button [35] of the remote control for
approx. 2 seconds to quit the alarm.
Storage when not using the product
If you will not be using the device for a long period of time, unplug it from the mains
and store the device in a dry and cool place. Also remove the battery from the remote
control.
Troubleshooting
The Internet Radio will not switch on.
Check that the power adapter has been firmly inserted into the wall socket and that the plug of
the power adapter cable has been inserted into the DC IN socket [15]. Plug the power adapter
into a different wall outlet, if possible.
Check that the main power switch [12] located on the back panel of the Internet Radio is
switched to “ON”.
Summary of Contents for 279398
Page 1: ......
Page 2: ......
Page 3: ...V 1 1 Deutsch 2 Français 57 Italiano 114 English 166 ...
Page 220: ......
