15
GB/IE
Only use the same type of bat-
teries / rechargeable batteries.
Do not mix used and new batter-
ies / rechargeable batteries.
Remove the batteries / recharge-
able batteries if the product will
not be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery/rechargeable battery!
When inserting ensure the cor-
rect polarity! This is shown
inside the battery compartment!
Clean the contacts on the bat-
tery and in the battery compart-
ment before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before use
Remove all parts from the packaging.
Installing / replacing batteries
(see Fig. A)
Set the On / Off switch
1
to
Position „0“ before installing the batteries
3
.
Open the battery compartment by squeezing
the dots located on front and back of base of
handle and pull off the cap
2
.
Slide out the battery tray
4
.
Insert / replace 4 batteries 1.5 V AA
3
into
the battery tray
4
, noting the polarity (+ and -).
The polarity is indicated inside the battery
tray
4
.
Slide in the battery tray
4
.
Reattach the cap
2
by aligning the dot on
cap with the one on the bottom of handheld
unit
11
. Push the cap on until it snaps in the
place.
Mounting the attaching cord
Thread the end of short loop of the attaching
cord
5
through the hole at base of cap
2
(Fig. B).
Insert the opposite part of the end of attaching
cord
5
with the plastic toggle through the
loop. The attaching cord is snug against the
cap
2
.
The large loop is now available to hang on a
peg or over a showerhead or faucet.
The cleaning brush can also stand on its base
for easy and upright storage.
Operation
Select a suitable brush head
6
,
7
,
8
,
9
,
10
based on the type of dirt and the surface
being cleaned.
To change the brush heads, grip lower half of
handheld unit
11
with one hand and brush
head with other hand.
Turn the brush counter-clockwise and pull up
(Fig. C1).
To attach another brush head, hold the hand-
held unit
11
with On / Off switch
1
toward
you and brush head down.
Align the guide lugs of the respective brush
head with the guide rails of the handheld unit.
Be aware of the different sizes of the guide
lugs, so that the brush head can only be in-
stalled in one direction. Then, push the brush
head onto the handheld unit
11
and tighten it
clockwise (Fig. C2).
