SDBS 2400 B2
GB
│
IE
│
37
■
Cleaning and maintenance
WARNING!
Risk of injury!
►
Before cleaning the appliance, disconnect the plug from the mains power
socket!
►
Allow the appliance to cool down completely if necessary.
►
Never immerse the appliance in water to clean it.
CAUTION
Damage to the appliance!
►
To avoid irreparable damage to the appliance, ensure that no moisture can
penetrate the appliance during cleaning.
►
Do not use aggressive scouring cleaners or solvents, or a wire brush or
other abrasive objects to clean the surfaces.
Self-cleaning function
♦
Fill the water tank
with water if necessary.
♦
If the appliance is switched on, set the temperature control
to "MAX" and
wait until the appliance has heated up.
♦
Hold the iron horizontally over a suitable container or sink.
♦
Press the "Self clean" button
%
for about 5 seconds. The self-cleaning
process starts and the "Self clean" button
%
flashes. Steam flows from
the steam exit holes in the sole of the iron
. Any impurities that may be
present are flushed out.
♦
As soon as the self-cleaning process is complete (after about 80 seconds),
the "Self clean" button
%
stops flashing.
Replacing the limescale filter
After pressing the steam button
for a total of around 11 hours, it is time to
replace the limescale filter
!
.
The appliance will notify you when the time comes: As soon as the "Anti calc"
button
1
flashes, you need to change the limescale filter
!
.
Proceed as follows:
♦
Set the On/Off switch
3
to the position "0" to switch the appliance off.
♦
Pull the water tank
by the grip
out of the base station
-
.
♦
Pull the limescale filter
!
upwards out of the limescale filter shaft.
Summary of Contents for 306479
Page 3: ...A B C ...
