11
GB
positioned just before the rear reference
ridges
|
11
and the side reference ridg-
es
|
13
.
4. Ensure again that there are no creases
in the film bag - especially in the area
above the welding wire
|
15
.
5. Close the lid
|
10
.
6. Use both hands to press firmly on the
edges of the lid
|
10
. They must audibly
click into place.
7. Press the button
|
3
. The LED lights
up. The film bag is first vacuum-packed
and then sealed.
The LED goes out when the process is
complete.
NOTE:
if the LED
|
3
does not go out and the
noise of the vacuum pump does not stop, de-
spite the fact that no further air is being
sucked out of the film bag, cancel the pro-
cess. Check that the film bag is in the correct
position in the device, and check for leaks.
8. Simultaneously, press buttons
|
7
in order
to release the lock of the lid
|
10
.
9. Open the lid
|
10
and remove the bag.
10. Check the welding seam. It should be a
smooth creaseless seam.
9. Cleaning and storage
DANGER! Risk of injury
through burning/scalding!
~
Allow the device to cool down com-
pletely before you clean it or put it
away.
~
The welding wire
|
15
becomes very hot
during operation. Do not touch the hot
welding wire
|
15
.
DANGER! Risk of electric
shock!
~
Prior to cleaning, disconnect the mains
plug
|
4
of the device.
DANGER! Risk of electric
shock due to moisture!
~
The device and the power cable with
mains plug
|
4
must not be immersed in
water or other liquids.
WARNING! Risk of material dam-
age!
~
Do not use any sharp or abrasive clean-
ing agents.
9.1 Cleaning
In order to ensure the proper function and
the full capacity of your device, clean it reg-
ularly.
•
Wipe down the housing of the device
with a damp cloth.
•
Prior to the next use, the device must be
completely dry.
Collector
1. Grasp the centre or both outer ridges
with your fingers and carefully lift the
collector for liquids
|
16
out upwards.
2. Drain the liquid.
3. Rinse the collector
|
16
under warm dish-
water or place it in the dishwasher.
Make sure it is dry before inserting it.
