SilverCrest SWDR 500 B1
68 - English
Press the "SET/STORE" button (9) briefly to cancel the enabled NAP timer
before the countdown ends. The remaining time of the previously set timer is
shown on the display. Press the "SET/STORE" button (9) briefly again to
relaunch the timer with the remaining time.
While the timer is running, you can change its value by pressing the "VOL-"
(12) or "VOL+" (4) buttons.
Please note: When the NAP-timer is activated do not press any
buttons apart from “SET/STORE” (9), “VOL-“ (12) or “VOL+” (4).
Otherwise the NAP-timer will be finished.
9.9 Stop watch
To use the stop watch, proceed as follows:
While the device is powered off, press the "MODE" button (15) three times.
The display (6) shows the stop watch icon (23) and "STOP"
00:00
(minutes:seconds)
and in the upper right corner the seconds/100 are
shown.
Press the "VOL+" button (4) briefly to start the stop watch.
Press the "VOL+" button (4) briefly again to stop or pause the stopwatch.
Press the "VOL+" button (4) again to resume the stopwatch from the currently
displayed time count.
Press the "VOL-" button (12) briefly to stop reset stop watch to
00:00
.
While the stop watch is running, the running time is shown on the
display (6). After resetting the stop watch to
00:00
, the display
toggles to the normal clock time after approx. 8 seconds.
