SilverCrest SWDR 500 B1
74 - English
Hold down the ‘POWER/SLEEP’ button (8) for approx. one second. The
multi-band radio (A) now switches on and the number 90 (for 90 minutes)
and the ‘SLEEP’ symbol (32) flash on the display (6).
Press the "POWER/SLEEP" button (8) as many times as necessary to display
the desired time in minutes (e.g. 40). Each press of the "POWER/SLEEP"
button (8) reduces the number of minutes before power off by 10 minutes.
The multi-band radio (A) automatically switches off after the selected number
of minutes (e.g. 40) has elapsed.
While the sleep timer is enabled, the "SLEEP" icon (32) is shown on the
display (6).
While the sleep timer is enabled, it is still possible to select a different
frequency band, to start a station search, to recall a stored station and to set
the volume.
You can cancel the enabled sleep timer by switching the device off.
9.23 Setting the alarm
You can set up to two alarm times (AL1 and AL2). Verify that the clock displays
the correct time. The alarm time can only be set while the device is powered
off. If it is powered on, press the "POWER/SLEEP" button (8) to power the
device off.
In the following we describe the setting for AL1. You can program AL2 in the
same way. If during the setting procedure no button is pressed for approx. 8
seconds, the settings are applied and the setting mode is quit.
Press the "M-/AL1" button (14) for approx. 1 second. The hours flash on the
display (6).
Press the "VOL-" (12) or "VOL+" (4) buttons to set the desired hour of the
alarm time. You can keep the buttons pressed to accelerate the digits count.
Press the "M-/AL1" button (14) briefly to apply the setting. The minutes flash
on the display (6).
