SDBS 2800 A1
■
6
│
GB
│
IE
│
NI
│
CY
Before first use
■
Remove the steam iron from the packaging .
■
Remove all packaging materials from the
appliance .
RISK OF SUFFOCATION!
►
Plastic bags can be dangerous . To avoid fa-
talities through suffocation, keep plastic bags
out of the reach of children .
■
Fill the water tank with water (See the chapter
"Filling the water tank") .
■
Insert the plug into a mains power socket
supplying an electrical current as detailed on
the rating plate .
■
Move the temperature control
6
to the "MAX"
position .
■
Wait for the iron to heat up until you hear a
beep .
■
Pick up the iron and press the steam blast button
4
a few times so that steam comes out of
the sole of the iron
q
.
■
Then iron over a piece of old piece of material
to remove any residues that may remain on the
sole of the iron
q
.
Filling the water tank
■
Hold the iron in your hand at an angle .
■
Open the cover of the filler opening for the
water tank
2
. This is marked with
.
■
Use the measuring beaker
e
to add tap water/
distilled water to the water tank up to no more
than the "MAX" marking that you can see
through the filler opening to the water tank
2
.
■
Close the cover of the filler opening for the
water tank
2
.
NOTE
If the mains water in your location is rated as
hard, it is recommended that you mix the mains
water with some distilled water . Otherwise, the
jets for the steam blast function could become
blocked with limescale prematurely .
To extend the optimal steam blast function, mix
mains water with distilled water according to the
table:
Water hardness
Ratio of distilled
water to
tap water
very soft/soft
0
medium
1:1
hard
2:1
very hard
3:1
Ask your local water utility about the water
hardness in your area .
Summary of Contents for 315311
Page 3: ...A B ...
