GB/IE/NI/CY
13
Please note:
If you turn the unit off, the fan will still run 30 seconds.
Then the unit will switch off. A countdown is shown on the
display (only after heating function).
TURNING OFF
To turn the device off, please press the
ON/OFF button
1
on the remote control
unit.
To disconnect the fan heater from the power
supply,
F
set the ON/OFF switch to posi-
tion ‘ ‘.
Control with aid of remote
control unit
Please note:
Before you completely shut down the de-
vice or disconnect it from the power supply, first turn it
off with the aid of the remote control unit and wait be-
fore it stops to run. The display shows a 30-second af-
ter-run timer. All the device functions are managed with
the aid of the remote control unit. The respective symbol
lights up on the display when the function is activated.
Explanation of the functions
TEMPERATURE SETTING
When setting the temperature, please note
that the device does will not heat, if the desi-
red temperature is not higher than the ambi-
ent temperature. To enable heating, the set
temperature needs to be at least 1°C higher
than the ambient temperature. The latter is
automatically displayed when the device is
turned on. After successful temperature set-
ting, the symbol appears on the display. The
fan continues to run.
Please note:
The fan runs independently of the temperature setting.
Press the temperature button
10
once to adjust the
temperature.
Press the plus key
8
to increase the temperature.
Press the minus button
7
to reduce the temperature
(between 18 and 45°C)
After setting the desired temperature, press the OK
button
5
or simply wait for 5 seconds without
making any entries.
Please note:
You can cancel your entry by pressing the cancel
button
6
.
TIMER SETTING
The purpose of the timer is to automatically
turn off the ceramic fan heater.
With the aid of the timer, you can select the turn-off time
in hour increments. Then the wall-mounted ceramic fan
heater will switch off automatically.
Please note:
As long as a weekly timer is activated,
the turn-off timer cannot be used. (See Chapter “De-
activation of the Week Timer)
Turn the device ON (see Starting). Press the timer but-
ton
4
repeatedly until you reach the desired number
of hours.
Example: If the device should automatically switch off
after 4 hours, press the timer button
4
until you see
"4H" on the display. Wait about 5 seconds. The infor-
mation is automatically transferred. Then the device will
be automatically turned off in 4 hours. If you want to
make sure that the timer entry has been transferred,
press the timer button
4
once more. Then ‘4H’ or your
entry will appear in the display.
By repeatedly pressing the timer button
4
, the timer
will be adjusted in 1-hour increments:
0H -1H -2H – 3H - 4H - 5H – 6H – 7H – 8H
OSCILLATION FUNCTION
To turn the device oscillation function on or
off, press the oscillation button
2
. If the
oscillation function is enabled successfully, it
will be shown on the display. The oscillation
function means that the blown air is distribu-
ted from the top to the bottom.