10 GB/IE/NI
Before use
Unpacking
Remove the packaging . Check if the product is
damaged .
Assembly
Accessory needed: Cross head screwdriver
Number of persons needed for assembly: 1 adult
Fig. Step
C
1 . Remove the knurled screw
[
14]
from the
pole on the motor unit
[
9]
.
2 . Place the pole on the base
[
13]
.
3 . Fasten with the knurled screw
[
14]
.
D
Remove the 4 lock screws
[
15]
from the motor
unit
[
9]
.
E
1 . Align the rear grille handle
[
5]
upwards
and to the rear . Attach the rear grille
[
4]
to the motor unit
[
9]
.
2 . Tighten with the 4 lock screws
[
15]
.
F
1 . Place the blade
[
2]
on the motor shaft
[
6]
.
Insert the pins on the motor shaft into the
groove
[
3]
on the rear of the blade .
2 . Tighten the lock cap
[
1]
on the motor shaft
[
6]
(direction of rotation: ) .
Fig. Step
G
1 . Remove the lock screw and the lock
nut
[
17]
from the front grille
[
18]
.
2 . Loosen the grille clips
[
16]
from the front
grille
[
18]
.
3 . Centre the hanging device
[
19]
of the front
grille
[
18]
on the rear grille
[
4]
.
NOTE:
The 4 grille clips
[
16]
must fit over
the frame of the rear grille
[
4]
and the
front grille
[
18]
.
H
Insert and fasten the lock screw and the lock
nut
[
17]
. Close the 4 grille clips
[
16]
over the
frame of the rear grille
[
4]
and the front grille
[
18]
.
NOTE:
The lock screw and the lock
nut
[
17]
are very small . Do not lose or drop
these fasteners .
Tilt adjustment
Loosen the knob
[
12]
.
Adjust the tilt angle manually .
Tighten the knob
[
12]
again .
Do not perform the tilt adjustment when the
product is in operation .
Summary of Contents for 384782 2107
