Silvercrest 66900, Operating Instructions Manual

11

Assembly/Handling and operation

SWW 1500 A1

GB

IE

Remove the device from the wall again. With an electric drill and an 8 mm 

♦

drill bit drill the hole to a depth of, at least, 40 mm, subsequently insert the 
rawlplug into the hole. 

Hang the device on the wall and tighten the screw with the angle bracket 

♦

 D

(see diagram Tightening the angle bracket).

OW R

+

Diagram Tightening the angle bracket

Insert the power plug into a mains wall socket.

♦

Handling and operation

NOTICE

All functions can be switched both with the buttons on the device and with 

►

the remote control.

In this section you receive important information for the handling and operation 
of the device.

Switching the device on and off 

With the main switch POWER 

6

 the device is completely disconnected from the 

mains power.

Firstly switch the main switch POWER 

♦

6

 on and/or lastly off  when you are 

no longer operating the device.

Heating operation

Activate the main switch POWER 

♦

6

 to switch the device on. In the display 

appears briefl y   and subsequently the current device temperature in the 
area of the integrated temperature sensor. The device is now in standby 
mode. In the display 

 the symbol for the frost protection function   blinks.

Press the button POWER/MODE 

♦

3

 and/or 

12

. The device switches on 

with the low heat output (LOW). In the display 

 appears  .

Press the button POWER/MODE 

♦

3

 and/or 

12

 again to set the high heat 

output (HIGH). In the display 

 appears  .

 D