Silvercrest 66900, Operating Instructions Manual

13

Handling and operation

SWW 1500 A1

GB

IE

Whilst the preset time is blinking in the display 

♦

 press one of the buttons 

+/- 

4

 and/or 

13

 to set the desired switch on time between 1 hour and 24

hours. As soon as the switch on time lights up continuously in the display 

the setting is adopted and the device switches on, after the time has expired, 
to the high heating output (HIGH).

Press the button AUTO ON 

♦

2

 and/or 

11

 again if you want to deactivate 

the switch on time. In the display 

 the indicator AUTO ON   goes out.

Overheating protection

With excessive temperature rise the device automatically switches off  and in the 
display 

 appears 

.

Should this occur...

Switch the device off  at the main switch POWER 

♦

6

 and pull the mains power 

plug from the wall socket. Allow the device to cool down for a few minutes

After the cause of the overheating has been removed, i.e. a covered heating 

♦

element, the device can be switched on again.

Frost protection function

The device is equipped with a frost protection function which automatically switches 
to the high heat output (HIGH) as soon as the room temperature falls below 7°C. 
When the room temperature has reached 10°C the appliance automatically 
switches back to standby mode.

Activate the main switch POWER 

♦

6

 to switch the device on and to shift 

into standby operation. In the display 

 the symbol for the frost protection 

function   blinks.

The device now switches on if the room temperature drops below 7°C.

Topple over protection

The device is equipped with topple over protection which automatically switches 
the heating element 

9

 off  if the device topples over. In addition a warning tone 

sounds for 1 minute.