SKHD 1800 A1
27
5. Unpacking and setting up
Note:
As the appliance and heating coils
are supplied with a thin film of grease, there
might be a
small
amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance from the packag-
ing.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
Warning!
– While the appliance is opera-
ting, there must be no flammable
objects (e.g. curtains, paper) in
the immediate vicinity of the
appliance.
– When setting up the appliance,
maintain a minimum distance of
0.5 m from other appliances and
the wall.
4. Select a location that complies with the
safety information (siehe „4.
Safety
information“ auf Seite 24).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note:
The appliance consumes up to
9 amperes of current (1800 watts). If
you have plugged other power consum-
ers into the same circuit, check that the
maximum load for the installed fuse is
not exceeded, as otherwise the fuse will
trip.
6. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning!
To avoid the danger of
an electric shock or burning:
– Remove the mains plug before
each clean.
– Allow the appliance to cool
down.
– Never immerse the appliance in
water.
– Never allow water or cleaning
agent to run into the appliance.
6.1 Cleaning the appliance
1. Carefully remove major dust deposits in
the air outlet grille
7
with a vacuum clea-
ner.
2. Remove any remaining dirt with a soft
brush.
Take care not to let any dust fall inside
the appliance.
3. Clean the outside of the appliance with a
damp cloth. You could also use a little
washing-up liquid.
Bedienung GB Seite 27 Mittwoch, 2. Mai 2012 12:36 12
