10
7. Cleaning
To ensure your appliance gives you lasting
service, you should clean it regularly.
Warning!
To avoid the danger of
an electric shock or burning:
– remove the mains plug before
each clean;
– allow the appliance to cool
down;
– never immerse the appliance in
water;
– never allow water or cleaning
agent to run into the appliance.
1. Carefully remove major dust deposits
from the protective guards with a
vacuum cleaner.
2. Remove any remaining dirt with a soft
brush.
3. Clean the outside of the appliance with
a damp cloth. You could also use a little
washing-up liquid.
Caution!
Never use caustic or abrasive
cleaning agents, as this could damage
your appliance.
4. Wipe the appliance with a cloth
moistened with clear water.
5. Do not use the appliance again until it
has dried completely.
8. Troubleshooting
Fault
Cause
Remedy
Appliance cannot be
switched on
Faulty fuse or wall socket
Select another wall socket
Faulty appliance
Have repairs carried out at a specialist
workshop or dispose of the appliance.
You will find the service address in
“Service Centre” on page 13.
Appliance switches
off automatically
Thermal cut-out has
triggered
Allow the appliance to cool down (see
“6.5 Thermal cut-out” on page 9)
Clean the appliance (see
“7. Cleaning” on page 10)
Only cold air is pro-
duced
Selected temperature has
been reached
Appliance switches on again automati-
cally as soon as the room temperature
falls
Select a higher desired temperature
RP90866 Konvektor LB3 Seite 10 Dienstag, 9. Juli 2013 12:52 12
