18
SDBS 2200 A1
GB
IE
Fault
Possible cause
Remedy
Water drips from
the soleplate
.
If the steam ironing is briefl y
interrupted, the cooling steam
condenses in the connecting
hose
. This can lead to drips.
This is normal. Hold the iron over
a cloth or container and press
the steam blast button
. After
a few seconds, steam will come
out of the soleplate
instead
of water. Then you can continue
ironing.
The set temperature is too low for
steam ironing.
Set a temperature suitable for
steam ironing (at least ● ●).
Wet patches occur
on the items being
ironed.
Such patches may occur due to
steam condensing on the ironing
board.
Wipe the wetness from the
ironing board and iron the wet
patches dry (without steam).
The water tank
is fi lled but the
"Water tank empty"
indicator
keeps
lighting up.
The water tank
is not fi rmly
attached to the appliance.
Check that the water tank
is seated correctly on the
appliance.
NOTE
►
If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.
Storage/disposal
Storage
If you plan not to use the appliance for a long period, store it in a clean, dry
place away from direct sunlight.
Disposal of the appliance
Under no circumstances should you dispose of the appliance with
the normal household waste. This product is subject to the provisions
of European Directive 2012/19/EU-WEEE (Waste Electrical and
Electronic Equipment).
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations. Please
contact your waste disposal facility if you are in any doubt.
Summary of Contents for 96145
Page 3: ...A B ...
