- 2 -
Technical data
Voltage :
220 - 240V~50Hz
Power consumption :
1100 W
Appliance description
1
Hotplate
2
Power cable
3
Connection socket
4
Grip
5
On/Off switch
6
Control lamp “Mains power connected”
7
Control lamp “Ready for use”
First implementation
• Remove all packaging materials from the appliance
and then clean it as described in the chapter
“Cleaning and Care”.
• Place the appliance on a dry, flat and heat-resistant
surface.
• Warm the appliance up as described in the chapter
“Utilisation”.
Note:
On the first usage, a slight odour can occur (minimal
smoke development is also possible). This is normal
and stops after a short time. Provide for sufficient
ventilation. For example, open a window.
• Remove the plug from the wall power socket.
Utilisation
• Place the appliance on a dry, flat and heat-resistant
surface.
• First insert the plug of the power cable
2
into
the connection socket
3
and then connect the
power cable
2
with a wall power socket. The
control lamp “Mains power connected”
6
glows.
• Position the On/Off switch
5
at “On” (--).
As soon as the appliance has reached its highest
temperature the control lamp “Ready for use”
7
glows.
• Position the On/Off switch
5
at “O”.
• First remove the plug from the wall power socket
and then the plug from the connection socket
3
on the appliance. The appliance is now inde-
pendant from mains power and retains its heat
for approx. one hour.
Risk of Burns!
Take hold of the food warmer ONLY by means of
the grips
4
provided on it. The other appliance
parts will be very hot!
• Place the food warmer at the place where you
wish to use it.
Note:
You can also leave the appliance connected to
mains power after it has been warmed up.
It could then happen that, during use, the control
lamp “Ready for use”
7
briefly extinguishes itself
and then glows once again. This indicates that the
set temperature had fallen and the appliance had
warmed itself back up.
Cleaning and Care
Attention!
Before cleaning, ALWAYS remove the plug from the
wall power socket! There is a risk of receiving an
electric shock!
Allow the appliance to cool down completely before
cleaning it. There is a danger of being burnt!
Do not use abrasive, aggressive or chemical cleaning
agents. These could damage the upper surfaces of
the appliance.
IB_54367_SSW1100A1_LB6 15.07.2010 9:35 Uhr Seite 2
