- 9 -
Configuration
Setting the time
The LCD display
q
shows you the time of day. You set this
as follows:
1.
Hold down the SET button
e
for a little longer than
3 seconds.
2. With the
or
button
h
select "CONFIG" and
confirm with the OK button
l
.
3.
In the LCD display
q
appears "TIME SETUP". Confirm
with the OK button
l
. The LCD display
q
now shows
"TIME" and the first number of the hour display blinks.
4. With
or
h
place the cursor on the position, in
which you want to make an entry and press the number
buttons
o
to set the hour and minutes. The switching be-
tween AM and PM you undertake with the
or
but-
ton
h
. Thereby "AM" stands for "ante meridium"
(= morning, 0:00 to 12:00 o'clock) and "PM" stands for
"post meridium" (= afternoon, 12:00 to 0:00 o'clock).
5.
With the OK button
l
you save the setting. In the LCD
display
q
appears "SUCCESS" and the previous mode
is accessed again. In the event of an error the LCD
display
q
shows "ERROR".
6.
To exit this menu press repeatedly the EXIT button
j
until the standard display appears in the LCD display
q
.
Adjust contrast
You can set the display's contrast as follows:
1.
Hold down the SET button
e
for a little longer than
3 seconds.
2. With the
or
button
h
select "CONFIG" and
confirm with the OK button
l
.
3. With the
or
button
h
select "CONTRAST" and con-
firm with the OK button
l
.
4. With the
or
h
button you set the contrast (
reduces the contrast,
increases the contrast).
Display readout:
0 = highest contrast
15 = lowest contrast
5.
With the OK button
l
you save the desired setting.
In the LCD display
q
appears "SUCCESS" followed
by "CONTRAST".
6.
To exit this menu press repeatedly the EXIT button
j
until the standard display appears in the LCD display
q
.
Summary of Contents for KH 2155
