Silvercrest KH 2155, Operating Manual

- 14 -

  Tips: 

Should AUX be selected as device then in step 6 after 

• 

the code you must press a fourth button to communicate 

the device type to the remote control: 

0 - TV 

3 - SAT.CBL 

1 - VCR 

4 - DVR.PVR 

2 - DVD.CD   

5 - AUDIO 

The AUX device appears in the LCD display 

• 

q

 as 

"AUX1", which is normal.

If the AUX device has been set with another programming 

• 

method please specify it first as AUX device in the direct 

code entry. Example The television shall be defined as an 

AUX device. For this in step 6 press as the fourth number 

the 0 so that afterwards the television can be programmed 

with the brand code search or the automatic code search.

Programming by automatic code search

This process can take several minutes per device since all 

codes for the selected device have to be gone through. 

Therefore this method should only be used when the device 

cannot be programmed via brand code search or direct 

code input or if your device is not listed at all in the manu-

facturers directory with device code list. 

A PC will not be considered a device with the automatic 

search.
Follow the steps listed below to carry out programming by 

means of the automatic code search.
1.  Switch the device that is to be controlled with the remote 

control on. With VCR/DVD/CD devices please insert a 

tape and/or disc.

2.

Hold down the SET button 

e

 for a little longer than  

3 seconds.

3.

In the LCD display 

q

 appears "CODE SETUP". Press  

the OK button 

l

. "BRAND SRCH" now appears in the 

LCD display 

q

. Press the 



 or 



 button 

h

 until "AUTO 

SRCH" is shown in the LCD display 

q

. Then press the OK 

button 

l

 to access the "automatic code search" mode.

4.

Press the device button 

r

 that corresponds to the device 

to be controlled (i.e. VCR).

5.

Point the remote control to the device and press the OK 

button 

l

 to start the search. The Infrared symbol 

3)

blinks, which shows the emission of Infrared commands.

6.  If the device reacts by switching off press the PAUSE 

;

button 

d

 to stop the code search.

7.  To test whether you have conducted the search fast 

enough press once the 



 button 

h

 then again the  



 button 

h

. If the device reacts again you have most 

probably found the correct code.