Silvercrest KH 2155, Operating Manual

- 16 -

  Tips:

1.

Do not use the following buttons for the learn function: 

all device buttons 

r

, LIGHT 

t

, MACRO 

2@

, FAV.CH 

2$

, 

d

, EXIT 

j

.

2.

When teaching please do not release the button of the 

original remote control until "SUCCESS" or "FAILED"  

appears in the LCD display 

q

.

3.

If whilst teaching when the display is showing "WAITING" 

still no button on the original remote control is pressed 

after 25 seconds the LCD display 

q

 shows "FAILED"  

followed by "SELECT KEY".

4.

If the memory is full the LCD display 

q

 shows "MEM 

FULL" and the learn mode will end.

5.

Whilst the LCD display 

q

 is showing "WAITING" in the 

learn mode the mode can only be ended with the EXIT 

button 

j

.

6.  During the learn mode or when the taught buttons are 

deleted the current mode can be exited with any button 

(except when "WAITING" is showing).

7.

With the EXIT button 

j

 you return to the previous status.

Code learn function

1.

Press the desired device button 

r

.

2.

Hold down the SET button 

e

 for a little longer than  

3 seconds.

3.  With the 



 or 



 button 

h

 select the menu "LEARNING" 

and then press the OK button 

l

.

4.

In the LCD display 

q

 appears "LEARN KEY". Then  

press the OK button 

l

. In the LCD display 

q

 appears 

"SELECT KEY".

5.

First press the button on the URC that is to be taught. In 

the LCD display 

q

 appears "WAITING". The URC now 

waits for the Infrared signal from the original remote  

control.

6.

Point the Infrared sensors 

2^

 of both remote controls  

towards each other.

7.

Now hold down the desired button of the original  

remote control until "SUCCESS" or "FAILED" appears  

in the display 

q

 of the URC.

8.

If in the LCD display 

q

 "SUCCESS" appears (process 

successful), you can teach further buttons begining  

with step 5. If "FAILED" appears (process unsuccessful) 

repeat the process in any case from step 5.

9.

To stop the learn process any device button 

r

 can be 

pressed. If in the LCD display 

q

 is shown "WAITING" 

then stopping can only be carried out with the EXIT 

j

button. After which the URC again returns to the "LEARN 

KEY" mode (see step 4).