- 39 -
Notice regarding disconnection from mainspower
To completely disconnect the device from mains power, the
plug must be removed from the power socket. For this purpose
the device must be set up so that constant, unimpeded access
to the mains power plug is guaranteed thus allowing for a
quick withdrawal of the mains plug in an emergency situation.
To eliminate the risk of fire the mains plug must be disconnect-
ed from the power source in the event that the device is not
going to be used for an extended period of time, for example,
during holidays.
Always take hold of the power cable by the plug. Do not
•
pull on the cable itself and never touch the power cable
with wet hands, this could result in either a short circuit or
you receiving an electric shock. Do not place the device,
furniture or anything else on the power cable and ensure
that it does not become clamped. Never make a knot in
the power cable and do not bind it together with other
cables. Place the power cable in a position where it cannot
be trodden on. A damaged power cable can cause a fire
or an electrical shock. Check the power cable from time
to time. Should it become damaged, contact your nearest
authorized customer service centre or dealer to have it
replaced.
The power plug must always be easily accessible, so that
•
in the event of an emergency the device can be quickly
disconnected from the mains power supply.
Risk of fire!
Do not use the device near hot surfaces.
•
Do not place the device in locations that are subject to
•
direct sunlight. If you do, it may overheat and become ir-
reparably damaged.
In order to ensure sufficient ventilation place the device in
•
a location that has at least 10 cm clearance between it
and the wall.
Never leave the device unattended while it is being used.
•
Never cover the ventilation slots of the device while it is on.
•
Avoid placing this device in locations that provide insuf-
ficient ventilation or hot locations and do not place the de-
vice in direct sunlight or under strong artificial light sources.
Do not place open fire sources, such as candles, on the
•
device.
When a storm and/or thunderstorm with the risk of lighten-
•
ing threatens disconnect the device from the mains power.
Risk of personal injury!
Keep the power cord and device away from children.
•
Children frequently underestimate the dangers of electrical
devices.
Provide a stable location for the device.
•
Do not operate the device if it has sustained a fall or is
•
damaged. Arrange for the device to be checked and/or
repaired by qualified technicians.
Keep batteries well away from children. Children can put
•
batteries into their mouths and swallow them. If a battery is
swallowed medical assistance must be sought immediately.
Danger of eye injuries!
This device is fitted with a "Class 1 Laser". Never look
•
directly into an open CD compartment The invisible laser
beam can damage your eyes.
CAUTION!
Information on surge voltage (EFT / rapid electrical
transition process) and Electrostatic discharge:
In the case of a malfunction due to rapid electrical transition
(surge voltage) or electrostatic discharge the product must
be reset (it may be necessary to disconnect the power source
and then reconnect it) to restore normal operation.
Note:
A case of electrostatic discharge occurs if you
walk with plastic-soled shoes over a carpet that also contains
elements of plastic. Through the friction of the shoe soles on
the carpet a charge is created in the body which discharges
itself as soon as you touch an electricity conducting object,
such as for example a door knob or the bodywork of a motor
vehicle. Thereby it is sufficient to approach the conductor to
within only a few cm. Direct contact is not required to effect a
discharge. The charge can also unload itself over an electri-
cal arc. A discharge is thus also possible through plastic hous-
ing components.
Note:
This device is equipped with non-slip rubber feet.
As upper surfaces can comprise of various materials and are
treated with various cleaning materials, it cannot be complete-
ly excluded that some of these materials contain components
that could attack and soften the rubber feet. If possible place
an anti-slip material under the feet of the device.
Observe copyright laws
When recording on CDs, USB memory mediums or from a
radio transmission obeserve the copyright laws of the country
in which the device is be used.
Positioning the device
Remove the Micro system and accessories from the packing.
>
Remove the transportation safety device from the CD com-
>
partment and all adhesive tapes/foils from the device.
Place the Micro system on an even, level surface. Place
>
the micro system in such a position that the CD tray cover
can open fully.
Place the speakers to the right and left of the Micro system.
>
