- 10 -
5.
Before fastening, place the elastic safety strap
that is secured to the LCD monitor, around the
headrest and/or headrest mounting.
6.
Hold the LCD monitor against the headrest and
pull the Velcro strap from the inside to the outside,
through the plastic tab. The Velcro must also here
point in the direction of the headrest.
7.
The plastic tab should lie to the left side, viewed
from the direction of travel, of the headrest
(as in the diagram above).
8.
Join the open end of the Velcro fastening strap
with its opposite side at the front of the headrest.
Make sure that the strap sits securely and is
tight.
9.
The Velcro fastening strap should be attached
to the centre of the headrest. If possible do not
impede the headrests height adjustment mecha-
nism.
Note:
If you are using the LCD monitor in a vehicle
make sure that the monitor does not interfere
with safety relevent components such as air-
bags, seat airbags or side airbags.
Fastening to active headrests is not recommended.
If you install the LCD monitors in a vehicle
make sure that the cables are layed in a manner
that will not cause them to be a trip hazard
and they do not obstruct entry to and exit
from the vehicle.
IB_KH2360_V5256_UK.qxd 31.08.2007 13:49 Uhr Seite 10
Summary of Contents for KH 2360
Page 40: ... 38 ...
Page 42: ......