Note:
For a television, press the device button TV (4), then continue
with step 8.
7. Press the up or down arrow button (6). The next device
appears in the LCD display (2).
8. Confirm the selection with the
OK
button (7).
SEARCH
KEY?
appears on the LCD display (2).
Note:
The remote control searches the device list in the forward direction.
To change the search direction, press "Minus" on the CH button
(17). To return to a forward search, press "Plus" on the CH
button (17).
9. Press the "Plus"
CH
button (17) repeatedly until your device
responds.
10. Press the
OK
button (7). The device code is saved.
SUCCESS
appears in the LCD display (2).
11. Press various buttons on the remote control to check the
setting. If your device only partially responds, repeat the
steps with the next device code.
BRAND CODES
Select a manufacturer code from the "Manufacturer codes"
table. The table can be found at the end of the operating in-
structions.
Note:
To conclude your input, press the EXIT button (8).
1. Switch on the device for which you would like to program
the remote control.
2. Hold the
S
button (5) pressed until
CODE-SETUP
appears
in the LCD display (2).
3. Press the right arrow button (6).
LIST CODES
appears in
the LCD display (2).
4. Press the down arrow button (6) repeatedly until
BRAND
CODES
appears in the LCD display (2).
5. Press the right arrow button (6).
MODE KEY?
appears in
the LCD display (2).
6. Press the desired device button (4).
DEVICE? TV
appears
in the LCD display (2).
Note:
For a television, press the device button TV (4), then continue
with step 8.
7. Press the up or down arrow button (6). The next device in
the list is displayed.
19
IB_KH2150_JOE23594_LB3bcI.qxd 05.08.2008 16:52 Uhr Seite 19
Summary of Contents for KH2150
Page 38: ...Description of fault ...
