Note:
Select a value between 1 and 90 minutes.
7. Press the up or down arrow button (6) to set the minutes.
8. Press the right arrow button (6).
SUCCESS
and the Zzz symbol
(25) appear in the LCD display (2).
9. Point the remote control at the television. After the configured
number of minutes elapse, the remote control will switch
off the television.
10. Press the
EXIT
button (8) repeatedly until the standard dis-
play appears in the LCD display (2).
Note:
If no button is pressed for approx. 30 seconds, the message
"TIMEOUT" appears in the LCD display (2). Then the standard
display is shown automatically.
TV SLEEP CLEAR
Switching off the
SLEEPTIMER
function for the television.
1. Hold the
S
button (5) pressed until
CODE-SETUP
appears
in the LCD display (2).
2. Press the down arrow button (6) repeatedly until
TIMER-
SETUP
appears in the LCD display (2).
3. Press the right arrow button (6).
TV SLEEP SET
appears
in the LCD display (2).
4. Press the right arrow button (6).
TV SLEEP CLEAR
appears
in the LCD display (2).
5. Press the right arrow button (6).
CONFIRM CLEAR
appears
in the LCD display (2).
6. Press the right arrow button (6).
SUCCESS
appears in the
LCD display (2).
7. Press the
EXIT
button (8) repeatedly until the standard dis-
play appears in the LCD display (2).
Note:
If no button is pressed for approx. 30 seconds, the message
"TIMEOUT" appears in the LCD display (2). Then the stan-
dard display is shown automatically.
TIMER SETUP
Note:
If a timer is already programmed, this must be cleared.
See the section "TIMER X CLEAR“.
The remote control can be programmed with four timers.
Each timer can switch on one device.
Each timer can be programmed with up to three buttons in
sequence.
22
IB_KH2150_JOE23594_LB3bcI.qxd 05.08.2008 16:52 Uhr Seite 22
Summary of Contents for KH2150
Page 38: ...Description of fault ...
