15
GB
10.2 Using and removing the blade
assembly
The blade assembly
19
is used to chop food.
The blender jug
5
must never be used without the blade as-
sembly
19
, since the blade assembly
19
seals the blender
jug
5
on the bottom.
DANGER! Risk of injury from cutting!
~
Please remember that the blades of the blade assem-
bly
19
are very sharp. Never touch the blades with
your bare hands in order to avoid cuts.
In order to remove the blade assembly
19
, proceed as fol-
lows:
1.
Position the blender jug
5
horizontally.
2.
Press the unlocking lever
27
on the under-
side of the blender jug
5
so that it points to
the open lock symbol.
3.
Pull out the blade assembly
19
carefully to-
wards the top.
In order to insert the blade assembly
19
, proceed as fol-
lows:
4.
Position the blender jug
5
horizontally.
5.
Insert the blade assembly
19
from the top.
Please take note that the two cams at the base of the
blade assembly
19
must be pushed through the two
recesses in the underside of the blender jug
5
.
CAUTION:
~
Ensure that the seal
18
is properly positioned on the
blade assembly
19
, since otherwise the contents
might escape.
6.
In order to lock the blade assembly
19
,
move the unlocking lever
27
on the under-
side of the blender jug
5
so that it points to
the closed lock symbol.
NOTE:
chop large pieces into smaller ones with an edge
length of approx. 3 - 4 cm before putting them into the
blender jug. Otherwise larger pieces might get stuck in the
blades.
10.3 Insert blender jug
1.
Place the blender jug
5
into the holder
11
. The front
side with the pot mark points towards you.
2.
Press the blender jug
5
downwards gently until the
flower-shaped hub of the blade assembly
19
engag-
es with the blade socket
12
.
NOTES:
• If the blender jug
5
cannot be pressed downwards,
you need to “wobble” it slightly so that the flower-
shaped hub of the blade assembly
19
in the blender
jug
5
engages with the blade socket
12
.
• Should the blender jug
5
not be positioned correctly, a
safety mechanism prevents the functioning of the de-
vice.
10.4 Insert and remove the mixer
attachment
The mixer attachment
21
serves to mix liquid foods, e.g.
to whip cream, beat egg whites, emulsify (e.g. mayon-
naise).
The mixer attachment
21
is put onto the blade assem-
bly
19
:
-
The wings of the mixer attachment
21
are located in
the spaces between the blades.
-
For further notes: see “Overview of functions” on
page 12.
13
19
18
__338924_1907_MC-Connect_GB_online.book Seite 15 Donnerstag, 12. Dezember 2019 10:09 10
