7
SFS 150 B3
GB
Handling and operation
In this chapter you receive important information for the handling and operation
of the appliance.
Inserting the tube fi lm
♦
Open the roll storage compartment
and insert a roll of tubular fi lm.
♦
Fold the guide rail
of the cutting device
to the rear and pull a piece
of tube fi lm through between the guide rail
and the appliance lid.
♦
Close the roll storage compartment
and fold the guide rail
of the
cutting device
back down.
Sealing the tube fi lm
IMPORTANT
►
For sealing use only fi lm made from HDPE (high density polyethylene) and
LDPE (low density polyethylene).
►
The foil thickness must be between 30-50 μ (0.03 - 0.05 mm). Otherwise,
the sealing seam will not be tight and the appliance could be damaged.
You can identify fi lms of this kind from the markings on the packaging. The
quality of the seal varies depending on the type and thickness of the fi lm.
►
Do not heat the supplied fi lm, for example in a water-bath or similar. It is
construed for temperatures up to a maximum of 60°C.
♦
Pull out the desired length of fi lm under the guide rail
of the cutting
device
.
♦
Press down on the cutting device
and then slide it to the left or right over
the bag width. You get a clean cut with straight-cut corners.
IB_71770_SFS150B3_LB4.indb Abs2:7
IB_71770_SFS150B3_LB4.indb Abs2:7
15.02.12 13:37
15.02.12 13:37
Summary of Contents for SFS 150 B3
