Silvercrest SILVERCREST KH 2156, Operation Manual

- 12 -

1.

Press the device button 

e

 for the device that is to be con-

trolled (i.e. VCR).

2.  Switch the device that is to be controlled with the remote 

control on. With VCR/DVD/CD devices please insert a 

tape and/or disc.

3.

Hold down the S button 

r

 for a little longer than 3 sec-

onds.

4.

In the LCD display 

q

 "CODE SETUP" appears. Press the 

OK button 

k

. "ENTER CODE" now appears in the LCD 

display 

q

. Press the 



 or 



 button 

t

 until "SEARCH 

CODE" is shown in the LCD display 

q

. Point the remote 

control to the device and then press the OK button 

k

 to 

access the mode "automatic code search".

5.

The search begins. Thereby the device sends, one after 

the other, the code numbers in ascending order. This is 

shown by a blinking infrared symbol 

2@

.

6.

When the device reacts by switching off press immedi

-

ately the OK button 

k

 to save the relevent code. The LCD 

display 

q

 shows briefly "OK".

7.  Check to see if the majority of your device's functions can 

now be controlled with the remote contol. If yes you have 

most probably found the correct code. In the event that a 

few functions are not working you can start the automatic 

code search again beginning with step 1.

8.

However if the device does not react any more you prob-

ably did not press the OK button 

k

 quick enough in step 

6. Then press repeatedly the EXIT button 

y

 to exit the 

menu and return to the standard display.

9.

Now hold down the device button 

e

 of the device for 

which you have just sought the relevent code. Below on 

the right in the LCD display 

q

 will thereby be shown the 

relevent code. Make a note of this number.

10. Then proceed as described in the preceding chapter 

"Programming by manual code entry" and check to see 

if the code with the next lowest number combination will 

function.

  Tips:

1.

When code search is activated all buttons except OK 

k

and EXIT 

y

 are ignored.

2.

Should the correct code be found, however the device's 

original remote control did not have a POWER button 

then it is possible that the device cannot be switched on 

or off remotely. Then try the buttons 

4

t

, CH + 

u

 or 

MUTE SWITCHING   

1$

.

3.  If the automatic search has reached the end of the code 

list it stops there. The display then returns to "SEARCH 

CODE".