Silvercrest SILVERCREST KH 2156, Operation Manual

- 15 -

Timer Setup

The URC offers 2 timer modes, sleep timer and event timer.

Sleep timer

1.

Press the device button 

e

 for the device that is to be con-

trolled (i.e. VCR).

2.

Hold down the S button 

r

 for a little longer than 3 sec-

onds. The notice "CODE SETUP" appears.

3.

Press the 



 or 



 button 

t

 until "TIMER SETUP" is 

shown. Press the OK button 

k

 "TIMER SLEEP" appears in 

the LCD display 

q

.

Confirm the selection of this function 

with the OK button 

k

.

4.

Now, below to the right in the LCD display 

q

 blinks the 

minutes for the remaining time of the selected device.  

Set with the 



 or 



 button 

t

 the desired value from 1 

to 99 minutes. Press the OK button 

k

 to confirm.

5.  Position the remote control in such a way that your infra-

red signal can reach the device to be switched off. After 

expiration of the set time the remote control will switch the 

device off.

6.  To check if the SLEEP timer is activated press the S button 

r

. Then below to the left in the LCD display 

q

 "SL" will 

be shown.

Event timer

The remote control has 4 event timers available via which 

you are allowed to send out specific series of button combi

-

nations at designated times.

1.

Hold down the S button 

r

 for a little longer than 3 sec-

onds. The notice "CODE SETUP" appears.

2.

With the 



 or 



 button 

t

 select "TIMER SETUP" and 

confirm with the OK button 

k

. "TIMER SLEEP" appears 

in the LCD display 

q

.

With the 



 or 



 button 

t

 select 

the desired memory slot "TIMER SETUP 1" to "TIMER 

SETUP 4" and confirm with the OK button 

k

.

3.  Now the hour of the time of day, to which the desired 

button combinations are to be carried out, blinks. Set with 

the 



 or 



 button 

t

 the desired hour and press for con-

firmation the OK button 

k

.

4.  Now the minutes of the time of day, to which the desired 

button combinations are to be carried out, blinks. Set with 

the 



 or 



 button 

t

 the desired minutes and press for 

confirmation the OK button 

k

.

5.

In the LCD display 

q

 you will see "TIMER X KEY" (X 

stands for the desired timer). Now press the desired  

device button 

e

 followed by the desired sequence of the 

button commands.

6.

Press the S button 

r

 to save your entry and to return to 

the timer menu.

7.  Procede in a similar manner in order to, if required,  

programme the other timer memory slots also.