SKM 550 B2
GB
│
IE
│
27
■
Proceed as follows to prepare the appliance for
operation using the continuous shredder
7
:
1) Press down the release button
e
and move
the pivot arm
t
into operating position 4
(see the section “Operating positions”).
2) Set the mixing bowl
6
into place. The base
of the mixing bowl
6
must click into the re-
cesses
u
on the appliance.
3) Press down the release button
e
and move
the pivot arm
t
into operating position 2.
4) Remove the protective cover from the drive
for the continuous shredder (Image C).
5) Insert the continuous shredder
7
into the
hub socket (aligning the marking “ ” on the
continuous shredder
7
with the marking “
”
on the pivoting arm
t
).
Turn it in an anti-clockwise direction until the
continuous shredder
7
clicks firmly in place
(and the marking “ ” on the continuous shred-
der
7
is aligned with the marking “
” on
the pivoting arm
t
).
6) Set the drive shaft
0
into place.
7) Depending on the task you want to perform,
place the cutting
q
, shredding
9
or grating
disc
8
onto the drive shaft
0
of the continous
shredder
7
.
8) Place the lid with the pusher
w
onto the con-
tinuous shredder
7
(so that the marking “
”
on the lid
w
is lined up with the marking “ ”
on the continuous shredder
7
) and lock the
lid in (marking “
” on the lid
w
is lined
up with the marking “ ” on the continuous
shredder
7
).
9) Turn the rotary switch
r
to the required setting.
NOTE
►
Do not press too much food into the continuous
shredder
7
. Take note of the table in the sec-
tion "Recommended filling quantities".
10) Add the ingredients through the opening in the
lid with the help of the pusher.
After using your appliance
1) Switch the appliance off using the rotary
switch
r
.
2) Turn the continuous shredder
7
anti-clockwise
and remove it.
3) Disassemble the continuous shredder
7
and
clean all parts as shown in the section “Clean-
ing and care”.
Working with the blender
WARNING! RISK OF INJURY!
►
Allow hot fluids to cool to a lukewarm tem-
perature (approx. 30 - 40°C) before pouring
them into the blender
4
.
WARNING! RISK OF INJURY FROM
SHARP KNIFE/ROTATING DRIVE!
►
Never put your hand into the attached
blender
4
while it is running!
►
Remove the blade from the blender
4
only
when it is at a complete standstill.
►
Only use the blender
4
with the lid firmly in
position.
►
In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
Proceed as follows to prepare the appliance for
operation using the blender
4
:
1) Press down the release button
e
and move
the pivot arm
t
into operating position 3
(see the section “Operating positions”).
IB_356370_SKM550B2_LB8.indb 27
23.10.2020 13:35:32
