■
12
│
GB
SKV 1200 A1
■
After cleaning, reassemble the blender:
–
Push the sealing ring
B
back into the recess
on the blade holder
A
with the blade
z
.
–
Place the blade holder
A
with the blade
z
back into the blender jug
C
so that the
blade
z
protrudes into the blender jug
C
.
–
Insert the blender tool
p
into the underside
of the blender
t
/ the blade holder
A
so
that the two catches on the underside of the
blender
t
/ the blade holder
A
grip into
the recesses in the blender tool
p
.
–
Turn the blender tool
p
towards (clock-
wise), so that the blade holder
A
with the
blade
z
sits hand-tight on the blender jug
C
.
In most cases, you can achieve sufficiently hygienic
cleaning of the blender
t
immediately after use in
the following way:
1) Put some water containing a little detergent
into the fully assembled blender
t
.
2) Place the blender lid
r
with measuring cup
e
in position so that the lips of the blender lid
r
also seal the spout .
3) Switch on the blender
t
for a few seconds .
4) Pour out the washing water . Any residues can
be removed with a washing-up brush .
5) Then rinse out the blender
t
with plenty of
clean water so that all detergent residues are
removed .
Storage
■
Store the cleaned appliance in a clean, dust-free
and dry location .
Troubleshooting
If the appliance suddenly stops working:
■
The appliance has overheated and triggered the
automatic safety cut-out .
–
Turn the rotary switch
3
to 0 .
–
Remove the plug from the wall socket .
–
Allow the appliance to cool for 15 minutes .
–
If the appliance has not yet cooled off com-
pletely after 15 minutes, it will not start .
–
Wait a further 15 minutes and try switching
on again .
If the appliance cannot be switched on:
–
Check that the plug is correctly connected
to a wall socket .
–
Check whether the swivel arm
1
is in the
wcorrect position .
Technical data
Supply voltage:
220 - 240 V ~
50/60 Hz
Power consumption:
1200 W
CO times:
Food processor 10 min .
Blender 3 min .
Max . capacity
Mixing bowl
6
:
approx . 6 .0 l
Blender
t
:
approx . 1 .5 l
All parts of this appliance that come into
contact with food are food-safe .
We recommend the following operating times:
When working with the kneading hook
0
, whisk
q
or beater
w
, allow the appliance to cool down
after 10 minutes of operation .
When working with the blender
t
, allow the ap-
pliance to cool down after 3 minutes of operation .
If you exceed these operating times, the appliance
can overheat and be damaged!
Summary of Contents for SKV 1200 A1
