SLE 280 A2
GB
│
MT
│
47
■
The appliance
is producing
no or limited
condensate.
The air inlet or air outlet aperture
is soiled or obstructed.
Ensure that the air inlet and air outlet
apertures are clean and free of
obstructions.
The room's windows and doors
are open.
Close the windows and doors.
Is the appliance running in the
AIR CLEAN programme? Dehu-
midification is not taking place.
Select a different programme, such as
AUTOMATIC MODE.
Water is
pooling on the
floor.
The appliance was overly agitated
during positioning. There is re-
sidual water in the appliance.
This is a normal feature of the ap-
pliance. When re-positioning the
appliance, ensure that it is not overly
agitated.
The air ejected
is warm.
Heat exchange process
This is a normal feature of the appli-
ance.
The error code
E 1
is flashing
on the display.
Coil temperature error
Contact the Customer Service depart-
ment.
The error code
E 2
is flashing
on the display.
The humidity sensor is defective.
Contact the Customer Service depart-
ment.
NOTE
►
If you are unable to resolve the problem applying any of the aforementioned
methods, please contact the Customer Service department
(see the chapter
Service
).
Disposal
Under no circumstances should you dispose of the appliance in
normal household waste. This product is subject to the provisions
of the European WEEE (Waste Electrical and Electronic Equipment)
Directive 2012/19/EU.
Dispose of the appliance via an approved waste disposal company or your
municipal waste disposal facility. Please observe applicable regulations.
Please contact your waste disposal facility if you are in any doubt.
Disposal of refrigerant
This appliance contains refrigerant R134a and must be disposed of by profes-
sionals. Please contact your waste disposal facility if you are in any doubt.