8
GB
6.1 Assembling the multi
chopper
CAUTION:
~
Depending on the hardness and consist-
ency of the food, do not fill the contain-
er
7
up to the
MAX
10
marking, as
this can cause the blade assembly
6
to
become blocked. Pay attention here to
the guideline values for various foods in
section “Processing table”.
1. Place the container
7
on the anti-slip
mat
11
.
2. Place the blade assembly
6
on the
peg
9
in the container
7
.
3. Fill the prepared food into the contain-
er
7
.
4. Place the working cover
5
onto the con-
tainer
7
in such a way that the blade
assembly
6
protrudes a little through the
opening in the working cover
5
.
5.
Figure A:
place the motor unit
4
onto
the working cover
5
. Rotate and jiggle
the motor unit
4
back and forth a little
until it sits firmly on the blade assem-
bly
6
and working cover
5
.
6. Insert the mains plug
1
into a wall sock-
et corresponding to the technical data.
6.2 Chopping
WARNING! Risk of material damage!
~
The multi chopper is designed for a
maximum operating time of 30 seconds
without interruption.
After this, the device must remain
switched off until it has cooled down to
room temperature.
•
Figure B:
for chopping, hold down the
button
I
2
or the button
II
3
.
• To switch off, release the pressed button
I
2
/
II
3
.
• Work using short pulses (1 pulse: press
for approx. 1 second). The number and
length of the pulses will depend on the
quantity and consistency of the food. See
the specifications given in section “Pro-
cessing table”.
• Repeatedly check the result. If the food
is not being chopped evenly:
- Release the button
I
2
/
II
3
.
- Pull out the mains plug
1
.
- Thoroughly shake the container
7
.
- If food is sticking to the inside wall of
the container, remove the motor unit
4
and the working cover
5
. Push the
pieces downwards using a spatula.
- Put all the pieces back together be-
fore you reinsert the mains plug
1
into
a wall socket and resume processing.
6.3 Remove food and
disassemble the multi
chopper
1. Disconnect the mains plug
1
from the
wall socket and wait for the standstill of
the blade assembly
6
.
2. Remove the motor unit
4
and the work-
ing cover
5
.
3. Remove the blade assembly
6
carefully
from the container
7
.
4. Remove the food, e.g. using a spatula.
5. Clean the device as soon as possible af-
ter use.
__326310_Multizerkleinerer_B6.book Seite 8 Montag, 19. August 2019 12:33 12
