Silvercrest SMZS 260 D3 Operating Instructions Manual Download

Page: 6 / 78

• This device can be used by people with

restricted physical, sensory or intellectu-
al abilities or people without adequate
experience and/or understanding if
they are supervised or instructed on
how to use this device safely and if they
are aware of the resulting risks.

DANGER! Risk of electric
shock due to moisture

• This device must never be operated

close to a bathtub, shower, filled hand
basin or similar.

• The motor block, the power cable and

the mains plug must not be immersed in
water or any other liquids.

• Protect the motor block against mois-

ture, drips and splashes.

• If liquid gets into the motor block, re-

move the mains plug immediately. Have
the device checked before reusing.

• Never touch the device with wet hands.
• If the device falls into water, disconnect

the mains plug immediately. Only then
is it safe to retrieve the device.

• Fill the vessel with a maximum of

200ml of liquid in order to prevent liq-
uid from getting into the motor block.

DANGER! Risk of electric
shock

• Only insert the mains plug into the wall

socket after the device has been com-
pletely assembled and filled.

• Only connect the mains plug to a properly

installed and easily accessible wall socket
whose voltage corresponds to the specifi-
cations on the rating plate. The wall socket
must continue to be easily accessible after
the device is plugged in.

• Ensure that the power cable cannot be

damaged by sharp edges or hot points.
Do not wrap the power cable around
the device.

• The device is not fully disconnected from

the power supply, even after it is

switched off. In order to fully disconnect
it, pull out the mains plug.

• When using the device, ensure that the

power cable cannot be trapped or
crushed.

• When removing the mains plug, always

pull the plug and never the cable.

• Disconnect the mains plug from the wall

socket…
… if there is a fault,
… when you are not using the multi

chopper,

… before you assemble or disassemble

the multi chopper,

… before you clean the multi chopper,

and

… during thunderstorms.

• Do not use the device if there is visible

damage to the device or the power cable.

• To avoid any risk, do not make modifi-

cations to the device. You also must not
replace the power cable yourself. Re-
pairs must be carried out by a specialist
workshop or the Service Centre.

DANGER! Risk of injury
from cutting

• The blade insert is sharp. Handle it with

care. When washing manually, the wa-
ter should be sufficiently clear that you
can see the blades easily.

• The device must never be operated with-

out the vessel.

• Never reach into the rotating blades. Do

not touch rotating parts with spoons or sim-
ilar utensils. Keep long hair or loose cloth-
ing away from rotating parts as well.

• The blade insert continues to rotate after

the device is switched off. Wait for it to
stop moving before you remove the
working cover.

__RP_78282_B4.book Seite 4 Montag, 17. Dezember 2012 8:32 20