GB/ IE
77
Attaching the presser foot holder
Attention:
2. Attaching the presser foot
3. Removing the presser foot
4. Attaching the edge/ quilting guide
Turn power switch to off ("O") when
carrying out any of the above operations!
1. Raise the presser bar (a) with the
presser foot lifter. Attach the presser foot
holder (b) as illustrated.
Lower the presser foot holder (b) using
the presser foot lifter, until the cut-out (c)
is directly above the pin (d)
The presser foot (f) will engage
automatically.
Raise the presser foot using the presser
foot lifter.
Raise the lever (e) and the foot
disengages.
Attach the edge/ quilting guide (g) in the
slot as illustrated.
Adjust as needed for hems, pleats,
quilting, etc.
c
d
e
f
e
g
b
a
1
2
3
4
Setting spool pins
The spool pins are used for holding the
spools of thread when feeding the thread to
the machine.
To use, pull up the spool pins. Push down
for storage.
A. Upper thread
B. Hole
C. Tangle
D. Spool pin
When using thread which has tendency
to tangle around a spool pin (D), thread
through the hole (B) of spool pin as
shown. The hole should face the thread
spool.
Note:
Getting ready
A
B
C
A
D
Summary of Contents for SNMD 33 A1
Page 3: ...8 6 7 12 11 10 9 5 4 3 2 1 13 14 15 15 18 16 17 19 21 n o p j m k c d g i e h f a b l 20 ...
Page 4: ......
Page 93: ......
