58 GB
4. Insert the collector
|
16
into the device
from above.
Sealing ring
1. Grasp the sealing ring
|
14
with two fin-
gers and lift it off upwards.
2. Rinse the sealing ring
|
14
under warm
dishwater. Make sure it is dry before in-
serting it.
3. Replace the sealing ring
|
14
in the re-
spective form inside the device. Ensure
that it lies in smooth contact and is not
wavy.
NOTE:
the sealing ring
|
14
is a wearing
part. Due to the high contact pressure, it will
lose its shape over time. In this case, replace
it with a new one (included in the items sup-
plied).
9.2 Storage
WARNING! Risk of material damage!
~
During storage, the lid
|
10
must not be
locked, but only loosely closed. Perma-
nent locking could damage seals
|
9
and
|
14
.
•
Figure B:
wind the power cable
|
4
around the cable spool
|
21
at the un-
derside of the device.
•
Store the device so that it is protected
against dust and dirt and out of the
reach of children.
10. Disposal
This product is subject to the
provisions of European Direc-
tive 2012/19/EC. The sym-
bol showing a wheelie bin
crossed through indicates
that the product requires sep-
arate refuse collection in the European Un-
ion. This applies to the product and all
accessories marked with this symbol. Prod-
ucts identified with this symbol may not be
discarded with normal household waste, but
must be taken to a collection point for recy-
cling electric and electronic appliances. Re-
cycling helps to reduce the consumption of
raw materials and protect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
11. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~
Do not attempt to repair the device
yourself under any circumstances.
Fault
Possible causes /
Action
No function
•
Has the device been
connected to the power
supply?
Seams are
not tight
•
Ensure that the film bag
is positioned smoothly
between the sealing
strip
|
8
and the welding
wire
|
15
.
•
The film was damp or
contaminated at the
seam.
Summary of Contents for SV 125 A1
Page 2: ...Español 2 Italiano 18 Português 34 English 48 Deutsch 62 ...
Page 19: ...17 ES ...
Page 35: ...33 IT ...
