SWK 360 A1
GB
│
IE
│
NI
│
41
■
♦
Align the helmet mount so that it is straight on the helmet.
♦
Pull the strap tight on both sides and push the clamps downwards.
The helmet mount must sit firmly on the helmet.
♦
Adjust if required so that the straps are pulled tight.
♦
Place the thread on the camera onto the fixture of the ball adapter and screw the camera
tight.
4.
4.
1.1.
2.
2.
3.
3.
4.
4.
1.1.
2.
2.
3.
3.
Fig. 13
NOTE
►
You can also install the helmet mount using the plug connector .
►
Extend the plug connectors / / as required or use the plug connector to ball joint
adapter .
Optionally, you can use the following accessories for installation of the helmet mount :
(+)
(+)
+
+