24
Select the desired code from the code list using the
number buttons 0-9 (3).
After inputting the fourth number the confirmation
message
will be shown.
The remote control will then revert back to normal use.
If the code is incorrect, the corresponding error message
will be shown on the display. The remote
control will then revert back to normal use.
Manual code search
Using the manual search you can find all codes for a
device, even those that are not included in the code list.
Turn the device on.
Hold down the setup (17) button
for about 3
seconds until
is shown.
Press OK (12)
.
will then appear on the
display.
Select the
menu using the navigation
buttons (13)
.
Summary of Contents for URC 101 DT
Page 16: ...14 Button layout ...
