52
Press OK (12)
to bring up
.
Confirm with OK (12)
again.
Select the source button (2) on which the device of the
original remote control was programmed.
The request
will be shown on the screen.
Select a button on the remote control on which the
function of the original remote control should be saved.
(Except the setup (17) and macro (15) buttons.)
Then the screen will show
. Press the button
on the original remote control of which the function is
to be transferred to the universal remote control. Hold
this button down until either the message
or
appears.
The following question will appear:
If you wish to carry out more learning functions then
confirm with OK (12)
. The request
will
appear again on the screen. Carry on as described
above.
If you wish to exit the learning function, press EXIT (16)
.
The remote control will then revert back to normal use.
Summary of Contents for URC 101 DT
Page 16: ...14 Button layout ...
