22
15. PROGRAMME SELECTION
AND SPECIAL FEATURES
Open the door and place the dirty dishes
inside the appliance.
Press the
"ON/OFF"
button for about
2 seconds
.
All the programme indicator lights will
flash.
T Choose a programme by pressing the
"
PROGRAMME SELECTION
" button. The
selected program indicator light will flash.
If you wish to select an option, press the
corresponding button (the indicator light
will turn on).
The option buttons can be selected or
deselected WITHIN one minute of The
programme commencing
.
Press the
"START"
button (the selected
programme indicator light will stop
flashing and remain on.
When the door is shut, after an audible
signal has sounded, the programme will
start automatically.
WITHIN one minute of the programme
commencing, another programme can
be selected, simply by pressing the
"PROGRAMME SELECTION" button.
The
“IMPULSE”
programmes use an
impluse washing technology, which reduces
consumption, noise and increases
performances.
Opening the door when a programme is
running is not recommended especially
during the main wash and final hot rinse
phases. However, if the door is opened
while a programme is running (for example,
to add dishes) the machine stops
automatically.
Close the door,
without pressing any
buttons
. The cycle will start from where it
left off.
Proceed as follows to change or cancel a
running program:
Hold the
"RESET"
button down for at
least 3 seconds. Audible signals will
sound, and the programme indicator
lights will turn on and off individually and
in sequence.
Close the door of the appliance.
The running programme will be cancelled
and all the programme indicator lights will
flash.
At this point a new programme can be
set.
Changing a running programme
WARNING:
If you open the door during the drying
cycle, an audible audio signal advises
you that the drying cycle has not yet
finished.
(only for FREESTANDING models)
visible control only A running program
can be interrupted without opening the
door by pressing the "ON/OFF" button.
In this case, simply press the
"ON/OFF" button again to restart the
cycle from where it left off.
Programme interruption
The “intermittent” working of the
washing pump MUST NOT BE
considered a malfunction, it is a
characteristic of the impulse washing
so must be considered a normal
function of the programme.
"IMPULSE" programmes
(only on some models)
Programme settings
