24
Press the
"DELAY START"
button (each
time the button is pressed the start will be
delayed by 3, 6 or 9 hours respectively,
and the corresponding time indicator light
will switch on).
To start the countdown, press the
"START"
button (the set time indicator
light will start to flash).
If a 9 hour delay is set, countdown will be
displayed by the 6h indicator light after 3
hours and the 3h indicator light after 6
hours.
At the end of the last 3 hours (at the end of
countdown) the 3h indicator light will stop
flashing and remain on to indicate the
washing phase and the programme will
start automatically.
If countdown has not ended, whereby the
programme has not yet started, it is
possible to change or cancel the delayed
start and select another programme or to
select/deselect the option button,
proceeding as follows:
Hold the
"RESET"
button down for at
least 3 seconds. Some audible signals
will sound and the programme indicator
lights will turn on and off individually and
sequentially.
The delayed start and the selected
programme will be cancelled. The
programme indicator lights will flash, the
dishwasher is ready start Programme.
The alarm for the programme end may be
muted as follows:
1.
Hold down the
"PROGRAMME
SELECTION"
button and at the same
time switch on the dishwasher by
pressing the
"ON/OFF"
button (a brief
audible signal will sound).
2.
Keep the
"PROGRAMME SELECTION"
button pressed for at least
15
seconds
(during this time,
2
audible signals will
sound).
3.
Release the button when the
second
audible signal sounds (3
"PROGRAMME
SELECTION"
indicator lights will come on).
4.
Press the same button again: the 3
indicator lights (which indicate that the
alarm is activated) will start flashing (to
indicate that the alarm is off).
5.
Turn off the dishwasher by pressing the
"ON/OFF"
button to confirm the new
setting.
To turn the w the same procedure.
The last programme used can be memorised
by following the procedure below:
1.
Hold down the
"PROGRAMME
SELECTION"
button and at the same
time
turn on
the dishwasher using the
"ON/OFF" button
(a short audible
signal will sound).
2.
Keep the
"PROGRAMME SELECTION"
button pressed for at least
30
seconds
(during this time,
3
audible signals will
sound).
3.
Release the button when the
THIRD
audible signal sounds (all the indicator
lights will flash).
4.
Press the same button again: the
flashing indicator lights (memory off) will
stop flashing and remain on (memory on).
5.
Switch off the dishwasher by pressing
the "ON/OFF" button to confirm the new
setting.
To disable the memory feature, follow the
same procedure.
The dishwasher must ALWAYS be off
before start of this procedure.
Memorising the last programme
used
The dishwasher must ALWAYS be off
before start of this procedure.
Muted END-OF-PROGRAMME
signal
