��
15
Unit HTL40 can be controlled either from the remote control or
from the keypad located on the top of the screen.
POWER-UP SEQUENCE
1) Set the LCD screen power switch at the bottom of the rear
panel to “I” (ON) (Fig.10A).
2) Wait for a few seconds.
3) Power-up the system by pressing one of the number buttons
0...9 on the remote control (Fig.10B).
������
����
���
��������
������
����
�
�
�
�
�
�
�
�
��
������
��
� �
�
� �
�
Fig.10
Two LEDs (green and blue) located on the front panel of the isplay
indicate the operating status of the system in accordance with the
contents of Table 2.
Unit HTL40 can be controlled either from the remote control or
from the keypad located on the top of the screen.
Table 2
������
����������������
�����
�������
�������
�������
������
�����
����
��������������
�������������������
�
SWITCHING ON AND OFF FROM STAND BY
Switching on the system (Fig.11):
• from the remote control (keys 0-9 )
• from the screen keypad (keys and ).
Typically, the picture will appear after 15-20 seconds.
RC
I 2005
LIG
HT
??
?
0
AUT
O
Fig. 11
Pressing a key from 1-9 on the remote control selects the corre-
sponding input; pressing 0 selects the input that was active at the
time the system was last switched off.
5 SWITCHING ON AND OFF