��
22
MENU
LANGUAGE
Lists the languages available for the On Screen Display menus.
IMPUTS LIST
The functions described below provide the facility to modify the
input selection menu to match the needs of the user.
The main screen displays all the input physically present on the
HTL40 unit.
If one or more of the inputs is not used it often proves helpful to
remove them from the list (called by pressing the “0” key).
For this purposes once the input has been selected, you can select
whether to activate the source or not in the drop-down menu that
is displayed by pressing the
◀
key (Fig.17).
The deactivation or activation of the source results in automatic
renumbering of the remaining active inputs.
The active sources (shown in the inputs selection menu) are dis-
tinguished by tick symbols.
������
���
������
���
��������
���
���������
��
����������
�
�
������
����
�
�
�
�
�
���
�
�
���
������ ��������
��� ����� ��������
��
�
�������
����
��� ��
���
���������
���
�
�
�
�
�
�
Fig.17
The user can assign an appropriate name to each input (e.g. the
name of the connected device).
This is possible by selecting the item NAME and entering up to 12
alphanumeric characters in the relative screen (for more details
refer to the “Text insert” section).
TEXT INSERT
Characters are entered using a specific text input menu (Fig.18). This
menu provides the facility to store text strings easily and quickly.
Y/C DELAY
In the case of Video and S-Video signals, it may be necessary to
correct horizontal colour misalignment within the projected image.
For a given video standard (e.g. PAL or NTSC) the stored value
does not normally require further fine-tuning, unless the source or
connection cable is changed.
Table 4
��������
������
�����
��
�����
���
��
������
������������
���
���
����
�������
����
�����������
�����
���������
�
�
�����
����������������
�����������������
��������
�
�
�
�
�
���������
�
�
�
�
���
��
SETUP
The setup menu contains less frequently used adjustments that may
be required during installation (e.g. On Screen Display language
selection or the display of Test Patterns).
POWER ON
If selected (AUTO), this option allows the system to be switched on
directly from the mains power supply once the initialisation phase
is terminated.
If disabled (STAND BY), at the end of the initialisation phase the
system assumes Standby status and awaits the power-up command
from the remote control or keypad.
TEST PATTERNS
Displays a series of four test patterns, which are useful when installing
the system and checking basic functions. Use the and keys to
browse through the test patterns.
INITIALS SETTINGS
Reconfigures the projector to original factory settings (except Posi-
tion, and Y/C delay).