6
ht5000HB - pro5dl
•
Be careful with cables.
Make certain cables are routed so that people will not be
impeded or tripped up.
Keep all cables away from children.
Install the unit as close to the wall socket as possible.
Avoid stepping on power cables, make certain they do
not become tangled, and never jerk or tug them; do not
expose them to sources of heat, and make sure they do
not become knotted or crimped. If the power cables be-
come damaged, stop using the system and request the
assistance of an authorised technician.
•
Disconnect the unit from the mains power during electrical
storms and when not in use.
To prevent damage from lightning strikes in the vicinity,
disconnect the unit during storms or when the system is
going to be left unused for a long time.
•
Avoid contact with liquids and exposure to damp.
Do not use the unit near water (sinks, tubs, etc.); do not
place objects containing liquids on or near the units and do
not expose them to rain, humidity, drops of water or sprays;
do not use water or liquid detergent to clean them.
•
Do not allow the units to overheat.
To prevent overheating, allow a free space of at least 40
cm at the back of the projector.
Do not obstruct the ventilation slots.
Do not place the unit near heat sources such as heaters,
radiators or other devices (including amplifiers) that gener-
ate heat.
Do not place the unit in an area where there is insufficient
space (shelving units, bookshelves, etc.) and in general
avoid placing it in poorly ventilated areas as this may
prevent sufficient cooling.
•
Never look directly at the projection lamp.
Never look directly at the objective lens when it is on as the
intense light may damage your eyes. Take particular care
that children cannot do so.
•
Take special care regarding movement of the lens.
Do not place objects in the slots on the side of the lens, and
also ensure that horizontal and vertical lens movements
are not impeded by external objects.
•
Place the unit on a stable surface.
Place the projector on a stable surface or use the ceiling
mounting bracket provided.
Never place the projector on its side or rear, on the lens or
top panel.
•
Do not insert objects through the openings in the unit.
Make sure that no objects are inserted inside the units. If this
should occur, disconnect the unit from the power supply
immediately and call an authorised technician.
•
Power saving.
We advise disconnecting the unit from the power supply
when not in use. In this way you will achieve considerable
power savings while at the same time protecting internal
electrical parts from wear.
•
hight Altitude.
During the installation, when using the projector over 3000
feet above sea level, set the “ALTITUDE” to “HIGH” from the
Service menu. Otherwise the life of the product may be
shortened.
•
PRODUCT DiSPOSAL
This projector is fitted with a pressurised lamp containing
a small amount of mercury. These lamps may be subject
to special disposal regulations due to environmental con-
siderations. For disposal or recycling information, please
contact your local authorities or, if you are located in the
USA, the Electronic Industries Alliance.
www.eiae.org
www.lamprecycle.org
