Lens Function
Zoom/Focus:
this item enables or disables the zoom and focus functions. It has
two status: Lock and Unlock.
Zoom:
adjust the zoom in the projected image.
Focus:
adjust the focus in the projected image.
Lens Memory Load:
load one of the Zoom&Focus&Image Shift memory.
Lens Memory Save:
save the present configuration of Zoom, Focus and Lens Shift,
in one of ten available memories.
Lens Memory Load and Save functions implements the Perfect-Fit feature. See the
relative chapter at page 45.
Press
◂
to reduce the zoom or focus of an image
Press
▸
to magnify the zoom or focus of an image
Power Settings
Direct Power On:
choose “On” to activate Direct Power mode. The projector will
automatically power on when AC power is supplied, without pressing the “Power”
key on the projector keypad or on the remote control.
Auto Power Off :
sets the countdown timer interval. The countdown timer will
start when there is no signal being sent to the projector. The projector will
automatically power off when the countdown has finished (in minutes). Range
[0 .. 180], with minimum increments step of 5 minutes.
Sleep Timer :
sets the countdown timer.
•
Sleep Timer (min.)
: sets the countdown timer interval. The countdown timer
will start with or without a signal being sent to the projector. The projector
will automatically power off when the countdown has finished (in minutes).
The Sleep Timer is reset every time when the projector is powered off. Range
[0 .. 990], with minimum increments step of 30 minutes.
•
Always On
: Check to set the sleep timer always on.
Power Mode (Standby):
set the power mode setting.
•
Active
: choose “Active” to return to normal standby.
•
Eco
: choose “Eco.” to save power dissipation further < 0.5W.
Security
Enable this function to prompt for a password before using the projector. Choose “On”
to use security verification when the turning on the projector. In this status appear a
quick menu to select the 4 digit password.
Choose “Off” to be able to switch on the projector without password verification.
The default Security password is “1234”.
NERO4
User Guide
39