ENG
12
12
10. MAINTENANCE
This tile cutter requires a simple maintenance, as described in the following operations, which you can easily perform. Any
manipulation of the machine must always be done with the engine stopped and the power cable disconnected. Do not forget
to completely remove all the complementary tools that you may be habitually using from the machine.
In case of observing anomalies or malfunctions, have the machine checked by a specialized technician.
Do not perform modifications of any kind on any of the pieces, elements or characteristics of the machine. In such case, the
manufacturer declines all responsibility that may result from the non-compliance with these recommendations.
CLEANING
1. At the end of each day having used the machine, remove
debris with a clean brush from the slots of the guide bridge
where the skids slide.
2. Vacuum the grooves of the chassis aluminium profiles.
REPLACEMENT OF THE FELT CLEANING WIPES.
3. Replace cleaning wipes when you notice that they have re-
duced or lost their cleaning power.
SKID SUBSTITUTION
1. Replace sliding skids when gaps begin to appear in the cu-
tting head.
Do not put oil in the slots: the sliding system works dry.
If the sliding of the head hardens, insert a clean cloth into the
slots and slide it several times until the slot is clean and smooth
ALIGNMENT
If the machine has suffered a fall or blow and needs to be re-aligned, SIMA has a specific tool to align the motor, guide bridge
and frontal rule in the same operation, without needing to use squares, measurements or complex operations. Please contact
our technical service for information.
Patin
Limpiador
