1. When storing, remove the screen prior to
deflating the frame, fold and roll it back onto
the tube for storage. (FIG. 9)
2. To deflate the frame, uncap one of the air valves
from either base. (FIG. 10)
3. Press in on the inner check valve. After 20 seconds
the seal should lock into place. This will allow you
to squeeze most of the air out prior to hooking up
the pump. (FIG. 11)
4. Squeeze the air out of the frame until it’s deflated
to ground level. (FIG. 12)
5. Attach the Deflate end of the AC pump to the air
valve on either base. *
6. Turn the pump to the “on” position for the next
few steps.
7. Layout the frame as shown in figure 12
8. Fold each base in half. Now begin to roll the frame
from one base down to the next base. (FIG. 13)
9. Turn the pump off after screen is rolled up
for storage
10. Unplug & remove the pump from the frame.
Pack the pump up for storage.
* NOTE:
THE PUMP CAN BE USED INTERMITTENTLY AS
YOU DEFLATE AND PACK UP THE FRAME. FEEL
FREE TO USE IT WHEN NECESSARY TO DEFLATE
ANY AIR AS NEEDED THROUGHOUT THE ENTIRE
DEFLATION / REPACKING PROCESS.
Screen Deflation and Repacking
It is recommended to remove the screen from the frame before packing to prevent
damage and creases in the screen.
Page 11
FIG. 10
FIG. 11
FIG. 12
FIG. 13
FIG. 9
