15
Remote Control Operation
The
MOON 340i
Integrated Amplifier uses the
CRM-3
full-function remote control (figure 7). It operates on the Philips
RC-5 communication protocol and can be used with other
Simaudio MOON components.
The
CRM-3
remote uses two CR-2032 batteries (included).
To install them, simply remove the two screws from the slidable
lower section of the back plate, insert the batteries
in the correct direction and then replace the back plate.
To engage the
CRM-3
remote for use with the
MOON 340i
Integrated Amplifier, you must first press the button labeled
AMP
.
The “ ” (Power) button, located on the upper left, will switch
the integrated amplifier to either ‘Standby’ or ‘On’ mode.
The
DISPLAY
button turns the front panel display on and off.
The 2 buttons labelled
INPUT
allow you to sequentially
scroll, either backwards or forwards, through all six (6) available
inputs. For example, to switch from the “CD” to the “VIDEO”
input you may press either
INPUT
three (3) times or
INPUT
three (3) times. Pressing and holding down either of these buttons
results in only a single change to the selected input.
The 2 buttons labelled
- VOL +
allow you to control the volume
level. Pressing
VOL -
results in a decrease in the volume level;
Pressing
VOL +
results in an increase in the volume level.
You may either press and hold these buttons down
or press them briefly to make volume adjustments.
The
MUTE
button turns off the output volume.
Pressing the “Mute” button a second time will reinstate
the output volume level back to its current setting.
NOTE: The buttons labelled
BAL
don’t affect
the operation of the
340i
.
Figure 7 : CRM-3 Remote Control
