2
Ioncell
5201128 Rev. D
CAUTION – Electrical Shock Hazard
Turn off power supply before cleaning bar or performing any maintenance
on the system. Electrical installation and repairs must be performed by a
skilled electrical engineer according to the applicable national and local
regulations. The equipment must be properly grounded. Grounding is
required to ensure safe and proper operation and to prevent electrical shocks
upon contact.
ATTENTION – Risque de choc électrique
Coupez l’alimentation électrique avant de nettoyer la barre ou d’effectuer
un entretien sur le système. L’installation électrique et les réparations
doivent être effectuées par un ingénieur électricien qualifié conformément
aux réglementations nationales et locales en vigueur. L’équipement doit être
correctement mis à la terre. La mise à la terre est nécessaire pour assurer un
fonctionnement sûr et approprié et pour éviter les chocs électriques lors du
contact.
CAUTION – Sharp Points
Risk of injury. Keep hands/fingers away.
ATTENTION – Points pointus
Risqué de blessure. Gardez les mains / doigts éloignés.
1. Read Instruction Manual completely before proceeding with installation or
operation. Failure to follow instructions may result in damage to Ioncell ionizer
or power supply.
2. The Ioncell ionizer, when operated with optional power supply, is to be
connected to main electric source with included 3-wire line cord and grounded
plug set. Do not remove electrical ground pin of the plug set.
3. A factory-qualified service technician must perform any required ionizer service
or warranty repairs. Please contact Simco-Ion Customer Service at 215-822-
6401 for information.
2. DESCRIPTION
The Simco-Ion Ioncell is a compact, steady state, bi-polar DC air ionizer designed
for easy installation, and minimal maintenance. It provides powerful ionization
through output tubes up to four feet in length. The single output tube also has the
ability to be split, allowing the Ioncell to service multiple locations from a single
ionization source. Options for Ioncell include:
•
Standard
: A fan for increased operating range
•
In-Line
:
– A ring or air knife output applicator for custom applications
– An airflow switch that automatically cuts off power when no airflow is
present, so potential excess ozone production is eliminated
