SIME FORMAT WALL HUNG BOILERS
MODEL 34i AND MODEL 34e
REF: INSTALLATION INSTRUCTIONS
19/02/04
24
USER’S INSTRUCTIONS
USER’S INSTRUCTIONS
USER’S INSTRUCTIONS
USER’S INSTRUCTIONS
WARNINGS
Should a fault occur, turn the boiler OFF, shut any gas valve, and contact the
Installer, or Hunt Heating.
DO NOT store or place in the immediate vicinity of boiler any flammable liquid or
materials.
Any serviced or maintenance of the boiler and heating system MUST be carried out
by an Authorised Person.
DO NOT block any grilles and air openings to the room in which the boiler is
installed.
LIGHTING AND OPERATION
To start the boiler, make sure that the gas valve is OPEN, the electricity supply is
turned ON and that the room thermostat is ON.
Turn the Selector Knob to the ON position, indicated by a star. A green light should
appear indicating that the electric power is ON.
The boiler will light automatically and continue to operate until the temperature set
by the room thermostat is obtained. It will then modulate to maintain the set
temperature.
To turn the boiler OFF, turn the Selector Knob to the OFF position. The boiler will
now shut down. If the boiler is not to be used for a lengthy period, it is advisable to
turn OFF the electricity supply and the gas valve.
Should the boiler not operate and a red light appears on the control panel, this
indicates that the boiler has failed to ignite correctly. There may also be an orange
light, which will either flash or be steady. A steady orange light indicates a faulty
boiler thermostat; a flashing orange light indicates insufficient water pressure in the
system. Both of them indicate that an Authorised Person must be contacted.
If there are no orange lights, turn the Selector Knob to the ignition position,
indicated by a flame symbol and hold until both lights flash then release.
Should the boiler fail to operate, contact an Authorised Person or the Hunt Heating
Service Department.