User manual - COUNTER SLB-94
ArES c
- this parameter enables the auto zeroing mode (
AUTORESET
function).
AUTORESET
clears
cycles counter
when it reaches the value equal to
SEtP 2
. This parameter can be set to:
“on”
-
AUTORESET
function is active,
“oFF”
-
AUTORESET
function is inactive.
rES t
- defines enabled sources of
totalizer
zeroing. Available options:
”mAn”
- manual reset only. This value enables only manual reset, which can be done
by pressing the [
RESET
] button on the front panel. This operation must to be
approved by [
ENTER
] button.
”EL”
- it enables the clearing of the counter by external electrical signal, feeded to
input
{ D }
. When an active state is delivered to this input, the clearing of the
counter happens. The active state must be longer than 1 ms. In this mode
manual clearing of the counter is unavailable.
”ALL”
- this option enables both manual (using
[RESET]
button) and electronic reset.
”nonE”
- this option disables both manual and electronic reset.
Zeroing of the totalizer can be done via RS-485 interface by presets of some
registers with value 0000h. Remote zeroing is available in
ALL
,
EL
and
mAn
modes too.
7.3.5.
”PrESCA” m
enu
This menu contains parameter which configure the prescalling parameters (recalculations
of counted pulses). This menu allows the user to set individual prescalers, and to scale the
counter in desired units. Available options:
ProFiL
- selection of the current profile. Profile is the set of the
muL
,
div
,
oFFSEt
and
Point
factors. It allows quick change of these parameters, what can be useful
to change the units. There are available 4 user profiles, and presently available
muL
,
div
,
oFFSEt
and
Point
, are related to present profile. To change
values of parameters related with other profile, first selection of desired profile must
be done.
muL
- multiply coefficient , range -99999 to 999999, ( the multiplier of the current profile
can be changed only)
div
- divide coefficient, range 1 do 999999, this parameter defines the internal modulo
counter, (the divider of the current profile can be changed only)
oFFSEt
- offset coefficient, range: -99999 do 999999 (the offset of the current profile can be
changed only),
28
i
Summary of Contents for SLB-94
Page 47: ...User manual COUNTER SLB 94 47...
