User manual - COUNTER SLB-94
In the most cases parameter
rESP
should be set to
Std
(no additional delay).
Unfortunately for some third party RS-converters
rESP
should be adjusted
experimentally. Table 7.1 contains most frequently used values.
”bAud” parameter
38.4
57.6
115.2
”rESP” parameter
10c
20c
50c
Tab.7.1. Settings of
rESP
parameter
7.3.7.
Menu ”SECu”
This menu contains presets connected with availability of other parameters:
SEtCod
- user password (4-digits number). If this parameter is set at value
0000
, user
password is turned off.
If the user do not remember his password, the access to the menu is possible
by the one-use password . To get this password please contact with
Marketing Division. Single use password can be used only one time, after
that it is destroyed. Entering this password causes in clearing of user
password, it means sets the user password to 0000 .
The one-use password can be used
ONE TIME ONLY
, it is impossible to use it
again! The one-use password can be restored by Service Division only.
A rEL1 ÷ A rEL4
- this options permits user (
on
) or prohibits (
oFF
) to modify the
thresholds of the relays/LEDs R1 ÷ R4 without knowledge about user
password. The functionality of quick view mode is showed in Figure 7.1.
A ProF
- this options permits user (
on
) or prohibits (
oFF
) to change of active
profile without knowledge about user password.
30
i
i
Summary of Contents for SLB-94
Page 47: ...User manual COUNTER SLB 94 47...
