SD9K User’s Manual
digital drum kit
audio equipment
headphones
mp3/cd player
power supply
power switch
When using an amplifier such as the Simmons DA50 or DA200S,
connect the Output L/MONO and R jacks on the rear panel to
the input of the amplifier. (For mono playback, use the L/MONO
jack; for stereo playback, connect both L/MONO and R jacks.)
The line output volume is controlled by the MAIN OUT
volume knob.
An optional set of stereo headphones can be connected to the
PHONES jack located on the side of the drum module.
The headphones output volume is controlled by the PHONES ( )
volume knob.
1. Connect the audio output of an MP3/CD player or other audio
source to the stereo AUX IN TRS jack on the rear panel.
2. The input signal is mixed with the drum signal,
allowing you to play along.
The volume of the external source is controlled by the AUX IN
volume knob.
Make sure the power is switched OFF. Connect the power
adapter to the DC IN jack on the rear panel.
NOTE:
Make sure the power is switched OFF when connecting the
drum module with external devices.
After confirming that all connections have been completed,
rotate the volume knob to the left (minimum volume level)
before switching the power on.
Set the power switch to the “ON” position. The Kit indicator
will light up and the display will show Kit number 001.
Caution: After the power is turned on, the SIMMONS
logo will appear on the LCD for a few seconds, and
then the DrumKit name will be displayed. Do not
press any pad or pedal until the Kit indicator
turns on.
Left Side Panel
Left Side Panel
Right Side Panel
Right Side Panel
Right Side Panel
12
